Log in
Latest topics
Who is online?
In total there are 5 users online :: 0 Registered, 0 Hidden and 5 Guests None
Most users ever online was 275 on 8/4/2021, 5:19 am
Small step forward, big step backwards
2 posters
Page 1 of 1
Re: Small step forward, big step backwards
Tony wrote:Ouch... What happened?
hit the railway sleeper on the edge of my drive :-(
I have to creep out onto the single track drive from the house to check for traffic from both directions. It is a bit of a blindspot until half the car is onto the drive. I turned a bit too early while I was checking the opposite direction. I must have parked a bit closer to that edge than I normally do.
The worrying thing is there was very little "resistance" and did not really feel I had made contact till it was too late. Before I got out of the car I assumed I had caught the wheel or maybe the rear of the wheel arch against the end of the sleeper - was a bit gobsmacked when I saw the size of the dent and therefore how easily it had caved in!
Just have to wait for the insurance company to tell me if they will pay for the repair or write it off. If it can be repaired (i.e. pulled out) it will cost around 700 but if it needs a new panel, they are listed at Rimmers for just under 500 so that plus fitting and spraying cost could take it well into "write off" territory so then have to go through the process of buying it back etc
StevePem- Registered user
Similar topics
» 3D TV's...
» Why was the air intake pointing backwards
» small clear out..
» 'F' leaves small hole in pocket.
» Regalia comes a step closer!
» Why was the air intake pointing backwards
» small clear out..
» 'F' leaves small hole in pocket.
» Regalia comes a step closer!
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
12/1/2017, 8:16 pm by chrisco59
» Adrian Flux - Roadhalo
7/1/2017, 1:56 am by DAN@ADRIAN FLUX
» Adrian Flux August Competition
16/9/2016, 10:16 pm by DAN@ADRIAN FLUX
» Adrian Flux Spring Forum Competition
1/4/2016, 7:52 pm by DAN@ADRIAN FLUX
» 2016 MG Spring Meeting in the Dolomites
20/1/2016, 8:46 pm by chrisco59
» Adrian Flux - Christmas 2015 Opening Hours
8/12/2015, 8:20 pm by DAN@ADRIAN FLUX
» Sywell Pistons and Props - Details?
21/9/2015, 12:17 am by StevePem
» Autumn Weekender - September 12th & 13th 2015
25/8/2015, 3:22 am by Rich
» MGF20 - Anybody going?
25/7/2015, 3:24 am by StevePem
» October 2015 - Invitation to Mg’rs based in UK to join us in South Tyrol
11/7/2015, 7:46 am by chrisco59