Wings

[Captain Jack]

Well finally managed to find my holy grail...........

...................a flame red offside wing!!!!!!

(Although its covered in a thin grit which seems reluctant to release itself from the paintwork)

But how do i remove the old wing from the car???

Haven't found a how-to so i can get started.

[Nick]

I've never done the wing myself, but I think its remove bumper undo top bolts, remove wheel arch liner and the bolts into the a pillar (socket and extension required). you should figure out what has to be removed by looking at the bolt holes in the new wing.

ref the grit, well worth buying a meguires clay kit, that should lift it out of the paint safely.

[daved]

Have a look here Seb. Apparently it's just four bolts! http://forums.mg-rover.org/showthread.php?t=305601&highlight=wing

Dave

[Seb]

Have a look here Seb. Apparently it's just four bolts! http://forums.mg-rover.org/showthread.php?t=305601&highlight=wing

Dave

Ha ha all them cuban cigars must a gone to your head Dave - I think you meant Captain Marcus!!

[daved]

I think it was the rum actually Seb

[Seb]

ha ha I like it!

[Guest]

Going from what I remember, it is 4 bolts across the top, bumper off and 2 or 3 screws towards the front, then 2 bolts at the bottom by the door, a plastic lug at the top by the door, and a bolt on the bracket half way up by the door. You can do it removing the wheel arch liner, or like I did with a socket set and some very long extensions.

https://s263.photobucket.com/albums/ii148/scubastewart/Lambo%20Doors/

[Sponsored content]